Delta Calibration v092 help (1 reply)

Hi,

I recently printed a kossel 20x20 (http://www.thingiverse.com/thing:154832) but most of the other part are stock rostock like, carbon arm with plastic jaw, end effector, XYZ carriages etc, I have spend many hours trying to calibrate the printer still no sucess! I followed step by step guide from

[minow.blogspot.com]

but I'm stuck at calibrating the center it too high, can't get it to lower down, his guide said

Quote

To lower the extruder nozzle
increase DELTA_RADIUS by increasing DELTA_SMOOTH_ROD_OFFSET(Marlin) or PRINTER_RADIUS(Repetier).

My default setting are 150, I have try to increase the value up to 300, it does nothing it did not lower the hotend at all, any idea what I'm missing here?

Note: I have eeprom disabled

Thanks