Strange tool paths in 1.0.6 (3 replies)

I upgraded to 1.0.6 when I fired up Repetier and was given the notice that a newer version was available. However, when I was calibrating and bed leveling I tried printing the calibration cube and there would occasionally be a glitch that would send the extruder to 0 on the Y (sometimes less), it only happened once or twice in the first couple layers and then was ok, but it was extruding the whole way, about 60mm. I didn't think it was a big deal but then I tried printing the same thing after re-slicing and it started doing it on every layer, sometimes in Y, then in X, and a couple times it went Max X and Y at the same time. I thought maybe it was Slic3r but then I tried it with Cura and the same thing happened. I'm not sure what's going on. I tried to re-slice and anything I could think of to find the issue.

Then I tried to go back to the 0.95F by uninstalling and re-installing, now it won't let me get past the splashscreen. I've run uninstall, registry cleaner, gone into the registry and gotten rid of anything tagged Repetier, and tried reinstalling either version and nothing works. Running win 7 pro 64-bit. Fortunately, this is on my laptop and I'm able to run 0.95F from my desktop, running win 7 ultimate 64-bit. Everything works great with the old version.

Mainly I just want to report the one problem with the erratic travels during print, I can probably figure out the install issue on my own. I'll include images shortly.