I'm having an issue with my printer shape settings. No matter what values I enter I can't get proper movement.
These are my parameters;
bed left 29
bed right 23
print area width 200
print area height 200
No matter what values I enter all movements start from my end stop position. So when I send a G1 X100 command it moves 100mm from the end stop and stops 29mm short of bed center. I've tried every positive/negative combination I can think of and it always stops short of bed center.
My latest settings are;
X Min -29 X Max 230 Bed Left 29
Y Min -23 Y Max 225 Bed Front 23
Print Area Width 230
Print Area Depth 225
EEPROM settings;
X 230
Y 225
Thanks in advance for any help.
These are my parameters;
bed left 29
bed right 23
print area width 200
print area height 200
No matter what values I enter all movements start from my end stop position. So when I send a G1 X100 command it moves 100mm from the end stop and stops 29mm short of bed center. I've tried every positive/negative combination I can think of and it always stops short of bed center.
My latest settings are;
X Min -29 X Max 230 Bed Left 29
Y Min -23 Y Max 225 Bed Front 23
Print Area Width 230
Print Area Depth 225
EEPROM settings;
X 230
Y 225
Thanks in advance for any help.