Found two problems:
1) It is possible to config "zero extruders", but software then locks up and dosen't run anymore. Solved changing (regedit) register value.
2) On a multiple extruder board (Megatronics 2.0) when turning on the heated bed, it turn on also the HEATER_1_PIN
Especially issue #1 is locking me...
Best Regards
Davide Ardizzoia
1) It is possible to config "zero extruders", but software then locks up and dosen't run anymore. Solved changing (regedit) register value.
2) On a multiple extruder board (Megatronics 2.0) when turning on the heated bed, it turn on also the HEATER_1_PIN
Especially issue #1 is locking me...
Best Regards
Davide Ardizzoia