I have just purchased a Due board managed to upload Repetier v0.92 Firmware to it using the Programming port. However I can't get it to talk to Repetier host (Either 0.95 or 1.05) I have set the reset to Due Native USB. The board appears to connect but I get 1 command waiting and this number then increments each time I try and send any characters from the G-Code entry box.
Is there any way of testing the board to see if it is a problem with the board or if it is with my setup ( I have noticed that the driver for the Native port seems to vary between a bossa usb port and a Arduino native usb seemingly at will depending what it picks up at the time which is why I suspect the board may be faulty especially has it had a little solder splash across the front of the USB socket but it didn't extend into the socket).
Any advise welcome.
Doug
Now sorted updated to latest Arduino (V1.5.8) re compiled and uploaded firmware then connected to Rep-Host using the PROGRAMMING Port and it now connects and talks correctly and can read the EEPROM Data from the radds board so happy days!:)-D
Is there any way of testing the board to see if it is a problem with the board or if it is with my setup ( I have noticed that the driver for the Native port seems to vary between a bossa usb port and a Arduino native usb seemingly at will depending what it picks up at the time which is why I suspect the board may be faulty especially has it had a little solder splash across the front of the USB socket but it didn't extend into the socket).
Any advise welcome.
Doug
Now sorted updated to latest Arduino (V1.5.8) re compiled and uploaded firmware then connected to Rep-Host using the PROGRAMMING Port and it now connects and talks correctly and can read the EEPROM Data from the radds board so happy days!:)-D