Hi,
I have downloaded a configured version of .91 from the website and it compiles fine, I can move all the axis, turn heaters on/off etc.
I need to change the Thermistor type: I have constructed a table of values in extruder.cpp as temptable5 and I've set NUM_TEMPS_USERTHERMISTOR0 to 1, and USER_THERMISTORTABLE0 to 31 .
Now it fails to compile in extruder.cpp with 'missing binary operator before token '31''. I've looked at this for some time and as you probably realise by now, I'm no propgrammer.
I'm hoping someone ( when they stop laughing) can show what is wrong.
I've attached the exruder.cpp and config.h.
Any help would be much appriciated.
William
I have downloaded a configured version of .91 from the website and it compiles fine, I can move all the axis, turn heaters on/off etc.
I need to change the Thermistor type: I have constructed a table of values in extruder.cpp as temptable5 and I've set NUM_TEMPS_USERTHERMISTOR0 to 1, and USER_THERMISTORTABLE0 to 31 .
Now it fails to compile in extruder.cpp with 'missing binary operator before token '31''. I've looked at this for some time and as you probably realise by now, I'm no propgrammer.
I'm hoping someone ( when they stop laughing) can show what is wrong.
I've attached the exruder.cpp and config.h.
Any help would be much appriciated.
William