Hi all,
I am having an error with Repetier-host V0.95C that is driving me crazy. I start up RH and then my printer or vise versa and it RH goes through the inital startup Finally I connect RH to the printer. I then go to the manual control tab and home the printer and then on my heated bed. Sometimes it works perfectly and heats up the bed, most times it starts to heat it up for a few seconds, turns off the heated bed and goes through the startup again (see photo). At any time I can hit the home button and it homes fine... just seems to be the hotbed control.....
If I can get it to work then it will run for hours with no issue.... just getting it to work is the challenge.
Edit: I updated to V0.95F and it is still doing it
Edit 2: I decided to try and run without the heated bed since I am using PLA and twice so far it has stopped printing and this is without the heatbed on...
I am having an error with Repetier-host V0.95C that is driving me crazy. I start up RH and then my printer or vise versa and it RH goes through the inital startup Finally I connect RH to the printer. I then go to the manual control tab and home the printer and then on my heated bed. Sometimes it works perfectly and heats up the bed, most times it starts to heat it up for a few seconds, turns off the heated bed and goes through the startup again (see photo). At any time I can hit the home button and it homes fine... just seems to be the hotbed control.....
If I can get it to work then it will run for hours with no issue.... just getting it to work is the challenge.
Edit: I updated to V0.95F and it is still doing it
Edit 2: I decided to try and run without the heated bed since I am using PLA and twice so far it has stopped printing and this is without the heatbed on...