I know this might be a recurrent topic in this forum but as a newbie I searched for similar problems on the forum and could not find a solution so I will try to list as much info as possible.
My Issue is that after uploading the Repetier firmware which I configured online for a delta printer, Repetier host does not recognise the firmware.
I currently use Repetier-Host Mac 0.56, the hardware is ramps 1.4 with endstops and one extruder but without a heatbed (it is a claystruder based on Jonhattan keep's one : [www.keep-art.co.uk])
I am attaching the config.h file in case it helps
Best
My Issue is that after uploading the Repetier firmware which I configured online for a delta printer, Repetier host does not recognise the firmware.
I currently use Repetier-Host Mac 0.56, the hardware is ramps 1.4 with endstops and one extruder but without a heatbed (it is a claystruder based on Jonhattan keep's one : [www.keep-art.co.uk])
I am attaching the config.h file in case it helps
Best