I used z min end stop for z-probe.
I can access G29 command via computer, but not for LCD display.
Question - Is it correct for LCD can't access autoleveling ??
Also, i set home the printhead after power on.
If i start autoleveling at this Home position, then i had to wait a long time for the printhead move down to the bed........
Is there any setting or anything that i can make the printhead move quicker when it is far away from bed ? And to keep the preset Z-probe's speed as slow when printhead close to the bed ?
I can access G29 command via computer, but not for LCD display.
Question - Is it correct for LCD can't access autoleveling ??
Also, i set home the printhead after power on.
If i start autoleveling at this Home position, then i had to wait a long time for the printhead move down to the bed........
Is there any setting or anything that i can make the printhead move quicker when it is far away from bed ? And to keep the preset Z-probe's speed as slow when printhead close to the bed ?