Looking for some direction for troubleshooting an odd issue.
Using the web configurator for .91 I've generated a config for my machine. I've ran into a snag where I can either have the EEPROM enabled OR the heat bed enabled, but not both. If I have both features enabled the upload starts but then hangs and never finishes.
I've attached 3 config files:
Configuration-EEPROM.h uploads and functions
Configuration-HeatBed.h uploads and functions
Configuratiion-EE+HB.h does not finish uploading
Does anyone have any insight on where I can go next?
I'm using a Ramps 1.4 board with a generic Mega2560.
Using the web configurator for .91 I've generated a config for my machine. I've ran into a snag where I can either have the EEPROM enabled OR the heat bed enabled, but not both. If I have both features enabled the upload starts but then hangs and never finishes.
I've attached 3 config files:
Configuration-EEPROM.h uploads and functions
Configuration-HeatBed.h uploads and functions
Configuratiion-EE+HB.h does not finish uploading
Does anyone have any insight on where I can go next?
I'm using a Ramps 1.4 board with a generic Mega2560.