Repetier 0.91, Arduino Due and RAMPS-FD (1 reply)

Does the current ARM version of repetier 0.91 support the RAMPS-FD boards for the Arduino Due? In the firmware config I only see these options. RAMPS-FD-> ( [www.geeetech.com] ) I know what RADDS is so I guess I am asking is 401 for RAMPS-FD? If not I'll create a new mapping for it.


//// The following define selects which electronics board you have. Please choose the one that matches your setup
// Arduino Due = 401 // This is only experimental
// Arduino Due with RADDS = 402

#define MOTHERBOARD 402

Is this ARM version in a working state or still very experimental?

thanks,
Brendin