Anyone here using the Rumba board from reprapdiscount?
I`m building my ORD BOT Hadron using this board + Bulldog Lite extruder.
I have studied the Marlin firmware and got X,Y and Z axis + extruder + end stops to work fine. But I plan to use dual drivers on the Z axis (one for each stepper) + dual Bulldog Lite extruder setup and have some problems finding how to configure this in Marlin.
Is this possible in Repetier?
Anyone have a config file to share where dual Z + dual extruder is in use?
I`m building my ORD BOT Hadron using this board + Bulldog Lite extruder.
I have studied the Marlin firmware and got X,Y and Z axis + extruder + end stops to work fine. But I plan to use dual drivers on the Z axis (one for each stepper) + dual Bulldog Lite extruder setup and have some problems finding how to configure this in Marlin.
Is this possible in Repetier?
Anyone have a config file to share where dual Z + dual extruder is in use?