cannot see Ramps SD card with Repetier firmware (no replies)

I am trying to get an sdramps adaptor running with Repetier firmware. Although the card can be seen if I load the sdrampstest to the Arduino, if I compile and upload Repetier firmware I get garbage - it looks like wrong bit rate or malformed data'

Response to sdrampstest

Quote

Initializing SD card...Wiring is correct and a card is present.

Card type: SD2

Volume type is FAT16

Volume size (bytes): 2001403904
Volume size (Kbytes): 1954496
Volume size (Mbytes): 1908

Files found on the card (name, date and size in bytes):
TEST/ 2013-12-06 16:07:30
YODA-L~1.GCO 2012-11-10 19:41:36 10244126
YODA-L~1.GCO 2012-11-10 19:41:36 10244126

But after compiling and uploding Repetier, using the Arduino serial monitor what I get is lots of

Quote

;ÌM/Hú
§jú
njú:jú:þ=CLnM¯mÌs~H/XëNNaïXÈ/X«NïggkJmN!9háìNN^ÁL'ax]H_Hw&þÌ.ÌÌ.ÌìÌÌ.Ì.ÌÌ.Ì.ÌNì.ÌÌÌìNìNìNì.ÌNÌNììNÌ.Ì.Ì.ÌNìánìVï_¹MàìM/"\(Hú
§jú
Njú:jú:þ}^_Ã6lnCmMÌs~H/XëNïNaïXÈX«N¯'gkJmN!9háìNN^Á{LÈ'ax]H_Hw&þNì.ÌÌNìÌNì.ÌÌNìÌÌNìÌ

Details: Repetier current development release.
Arduino 1.0.5
Ramps 1.4
SD card Transcend 2GB
In configuration.h
Bit rate set to 115200
sdsupport set to true

Thanks for any advice or clues.

Mike