Repetier Host and Marlin firmware Compatible? (1 reply)

Hi all,

I've just set up my new 3D printer (helloBEEprusa Serial 1111500275-to-X). The machine works fine itself, but I am finding it impossible to connect it with Repetier-Host software.

The firmware of the printer is Marlin 1.1.0-RC3.

So my question is, is Repetier Host compatible with this firmware? The program shows this error message: "Unknown printer firmware".

Is there anything I can do to make it compatible?

I am using a MAC !

I need Repetier Host since it has manual control.

Thank you very much, any help will be appreciated!