Hi everyone,
Let me preface all of this by saying THANKS FOR HELPING.
OK, so, I built myself a RepRap Prusa i3 from a kit I purchased on eBay. I just finished calibrating the unit and had my first print come out great!
I am using Repetier software to control the printer. I noticed that when I connect to the printer and load an STL file, sometimes it says (under manual tab): 'Print Job Finished'. It's not happening all the time, but, it is most annoying. Even if I import a completely different STL file, I get the same message. I don't have a workaround to solve this problem. Anyone have any suggestions as to what I could try?
Another question, after I import an STL file and tab through to 'Manual Control', the picture on the item disappears from the window on the left. It is just blank. Any clue as to why this is?
Many thanks!
Let me preface all of this by saying THANKS FOR HELPING.
OK, so, I built myself a RepRap Prusa i3 from a kit I purchased on eBay. I just finished calibrating the unit and had my first print come out great!
I am using Repetier software to control the printer. I noticed that when I connect to the printer and load an STL file, sometimes it says (under manual tab): 'Print Job Finished'. It's not happening all the time, but, it is most annoying. Even if I import a completely different STL file, I get the same message. I don't have a workaround to solve this problem. Anyone have any suggestions as to what I could try?
Another question, after I import an STL file and tab through to 'Manual Control', the picture on the item disappears from the window on the left. It is just blank. Any clue as to why this is?
Many thanks!