Hi everyone,
I'm looking for help with an issue that came up when I upgraded from 0.95f to 1.0.4. When I send the command to begin printing a sliced part, the printer will move into position and run for about 3 seconds before locking up and crashing all the USB 3.0 ports on my computer. Only a complete restart gets my USB's working again. Using manual control to heat the bed/nozzle, extrude, or move the printer does not cause any issues, it is only when using the "Print" function.
Additionaly, I tried running it from my laptop which still has V0.95f on it, and once more I have no issues, so I don't beleive it is an issue with the printer. Any leads would be greatly appreciated, as I really like the new interface of V1.0.4!
Thanks!
I'm looking for help with an issue that came up when I upgraded from 0.95f to 1.0.4. When I send the command to begin printing a sliced part, the printer will move into position and run for about 3 seconds before locking up and crashing all the USB 3.0 ports on my computer. Only a complete restart gets my USB's working again. Using manual control to heat the bed/nozzle, extrude, or move the printer does not cause any issues, it is only when using the "Print" function.
Additionaly, I tried running it from my laptop which still has V0.95f on it, and once more I have no issues, so I don't beleive it is an issue with the printer. Any leads would be greatly appreciated, as I really like the new interface of V1.0.4!
Thanks!