Hello @repetier,
I had some time this weekend to install and configure Repetier-Server and downloaded and installed the Repetier-Host 1.02 windows version. After a small update in the small plugin I write for some extra controls (2 new interface methods to implement, nothing major) I was up and running with the new Repetier-Host version.
Repetier-Server was a nice experience as I am not too well versed in Linux, but was looking for something useful to do with my Raspberry Pi. I started from scratch with Raspbian, and got Repetier-Server compiled and running according to the install instructions. I was able to successfully send commands and gcode via the browser...awesome!
I am wondering if Repetier-Server on the Pi can act as a facilitator for the newly implemented Repetier-Host TCP connection? Currently, Repetier-Server is on port 8080 as in the default configuration. But I am assuming that does not mean that my printer will magically be seen on port 8080 at the set IP address (well I assumed and it did not work). Is there any facility in Repetier-Server to set up printers to be seen from the Repetier-Host? I apologize if I have overlooked anything that would be an obvious answer to my question.
Thanks!
I had some time this weekend to install and configure Repetier-Server and downloaded and installed the Repetier-Host 1.02 windows version. After a small update in the small plugin I write for some extra controls (2 new interface methods to implement, nothing major) I was up and running with the new Repetier-Host version.
Repetier-Server was a nice experience as I am not too well versed in Linux, but was looking for something useful to do with my Raspberry Pi. I started from scratch with Raspbian, and got Repetier-Server compiled and running according to the install instructions. I was able to successfully send commands and gcode via the browser...awesome!
I am wondering if Repetier-Server on the Pi can act as a facilitator for the newly implemented Repetier-Host TCP connection? Currently, Repetier-Server is on port 8080 as in the default configuration. But I am assuming that does not mean that my printer will magically be seen on port 8080 at the set IP address (well I assumed and it did not work). Is there any facility in Repetier-Server to set up printers to be seen from the Repetier-Host? I apologize if I have overlooked anything that would be an obvious answer to my question.
Thanks!