I just downloaded version 1.00 beta and noticed there was a new tab in the printer settings for the Extruder... the confusing part is that some of that info is also in the printer settings within Slic3r and in the EEprom... Nozzle diameter/offset etc.
Is there an explanation of what the new settings do in RH printer settings and if all (eeprom/RH printer settings/Slic3r printer settings) need to be set? Does anyone know if one set of settings trump the other 2 settings and if so whats the logic behind 3 sets of the same input?
The issue for me is that I mess with my nozzle size a lot .25 -.4 - .6 and now it seems like I need to change it in multiple spots and most likely I will forget one or the other or the other...
also I'm not sure about anyone else but my eeprom is the real offset but it is in steps (not mm), then my slicer offset for both extruders is really only extruder1's offset so that it stays centered on my plate and now I have no clue what info to put in the RH printer settings for offset. Just seems to me that one should drive the next.... any one else feel like they are chasing there tail?
Is there an explanation of what the new settings do in RH printer settings and if all (eeprom/RH printer settings/Slic3r printer settings) need to be set? Does anyone know if one set of settings trump the other 2 settings and if so whats the logic behind 3 sets of the same input?
The issue for me is that I mess with my nozzle size a lot .25 -.4 - .6 and now it seems like I need to change it in multiple spots and most likely I will forget one or the other or the other...
also I'm not sure about anyone else but my eeprom is the real offset but it is in steps (not mm), then my slicer offset for both extruders is really only extruder1's offset so that it stays centered on my plate and now I have no clue what info to put in the RH printer settings for offset. Just seems to me that one should drive the next.... any one else feel like they are chasing there tail?