Hello,
Was reluctant to upgrade to .95 after my first attempt were not so successful with slicing. Another thread here helped me with the sli3r directory settings. I have another issue that I did not have with .90 which also deals with sli3r, but not sure how to fix it.
The gcode generated is not in the position I want it. I have a piece at 0,0 which is the bottom left corner of my machine. When I run sli3r from Repetier, I see this in the promt in Repetier:
Where is this --print-center 180,50 coming from!? I never set anything besides that I want the prints to center around 0,0. In .90 I never had this issue, and I am not sure where Repetier is getting these paramters. Any ideas?
Was reluctant to upgrade to .95 after my first attempt were not so successful with slicing. Another thread here helped me with the sli3r directory settings. I have another issue that I did not have with .90 which also deals with sli3r, but not sure how to fix it.
The gcode generated is not in the position I want it. I have a piece at 0,0 which is the bottom left corner of my machine. When I run sli3r from Repetier, I see this in the promt in Repetier:
Quote
12:02:32.760 : Slic3r command:C:\Program Files\Repetier-Host\Slic3r\slic3r.exe --load "C:\Users\wiso\AppData\Local\RepetierHost\slic3r.ini" --print-center 180,50 -o "C:\Users\wiso\AppData\Local\RepetierHost\composition.gcode" "C:\Users\wiso\AppData\Local\RepetierHost\composition.obj"
Where is this --print-center 180,50 coming from!? I never set anything besides that I want the prints to center around 0,0. In .90 I never had this issue, and I am not sure where Repetier is getting these paramters. Any ideas?