Hi,
i have a problem with repetier firmware on Delta printer. It seems to print very fast and well, but with some gcode (with cones and curves) the buffer on lcd goes under 10 and the movements become very jerky and the print worst. It make me crazy.
Anyone could help me to set correctly the firmware please?
My Configuration.h is here
PS electronics is an Ultimaker clone with DRV8825
...and on linear shapes it work very well but i understood that Repetier firmware should have been the best at all on Delta cinematics !
PPS forgot to mention Cura for slicing software, but also with Slic3r it's the same: printing cones sucks ... i think it's a wrong setting in firmware
i have a problem with repetier firmware on Delta printer. It seems to print very fast and well, but with some gcode (with cones and curves) the buffer on lcd goes under 10 and the movements become very jerky and the print worst. It make me crazy.
Anyone could help me to set correctly the firmware please?
My Configuration.h is here
PS electronics is an Ultimaker clone with DRV8825
...and on linear shapes it work very well but i understood that Repetier firmware should have been the best at all on Delta cinematics !
PPS forgot to mention Cura for slicing software, but also with Slic3r it's the same: printing cones sucks ... i think it's a wrong setting in firmware