Gday guys,
I have just received my Orion Delta and printed out the sample files with no problems.
I then down loaded a few file from thingiverse which looked good in Repetier except they did not drop into the centre of the work area ( problem 1. )
Prblem 2 When I sliced them The G code was produced as I expected.
But when I hit the go button the printer did not lay down the first layers the filament just clogged up at the hot end.
I then checked the sample files again and they worked perfectly.
There must be a problem with the setup but I just cannot find it.
HELP required.
Is there a set of standard config settings for Orion Delta for Repetier Host?
cheers
Harrow
I have just received my Orion Delta and printed out the sample files with no problems.
I then down loaded a few file from thingiverse which looked good in Repetier except they did not drop into the centre of the work area ( problem 1. )
Prblem 2 When I sliced them The G code was produced as I expected.
But when I hit the go button the printer did not lay down the first layers the filament just clogged up at the hot end.
I then checked the sample files again and they worked perfectly.
There must be a problem with the setup but I just cannot find it.
HELP required.
Is there a set of standard config settings for Orion Delta for Repetier Host?
cheers
Harrow