I had built a mini-kossel delta printer and would like the fine tune the print quality. And I think the repetier wiki's "print quality article" is the best introduction on this topic.
Flowing the instruction on the article. I hope could change the K and L with the advance test cases. But I can't find it in the repetier-host software. Is it already removed?
Another question is I used a 128*64 LCD as the UI and it seems too "heavy" for a mega2560 mainboard. During the printing whatever from SD or through USB directly, every time when I switch menu, there is a print pause triggered :-(. And I have tried several parameters. A small motion segment per second dosen't change anything. And a larger motion buffer, e.g. from original 16 to 20 or 32 even died the whole firmware(maybe insufficient memory)? Is there any suggestion? Thanks in advance
Flowing the instruction on the article. I hope could change the K and L with the advance test cases. But I can't find it in the repetier-host software. Is it already removed?
Another question is I used a 128*64 LCD as the UI and it seems too "heavy" for a mega2560 mainboard. During the printing whatever from SD or through USB directly, every time when I switch menu, there is a print pause triggered :-(. And I have tried several parameters. A small motion segment per second dosen't change anything. And a larger motion buffer, e.g. from original 16 to 20 or 32 even died the whole firmware(maybe insufficient memory)? Is there any suggestion? Thanks in advance