I have a large printer that has been running Marlin with no issues for months.
Really enjoying Repetier Host and wanted to move the rest of the way with the firmware.
Got the settings moved over and endstops set.
However, I'm having problems with the movement.
Marlin had:
X 87.67 steps per mm
Y 45.17 steps per mm
Z 1600 steps per mm
With the same settings in Repetier I'm moving roughly double what I should be. Acceleration doesn't seem to change no matter what I do and movement is sharp and jerky.
Any ideas?
Really enjoying Repetier Host and wanted to move the rest of the way with the firmware.
Got the settings moved over and endstops set.
However, I'm having problems with the movement.
Marlin had:
X 87.67 steps per mm
Y 45.17 steps per mm
Z 1600 steps per mm
With the same settings in Repetier I'm moving roughly double what I should be. Acceleration doesn't seem to change no matter what I do and movement is sharp and jerky.
Any ideas?