Dear all,
This a bit a newbee question, I am building a Rostock like delta printer controlled by Gen7 1.4.1 (Atmega 644 @20Mhz I expected the little overclock of the gen7 could be beneficial on a delta where controller speed is an issue)
Since the Repetier Firmware (V0.82.2) which seems the most advanced for delta printers I tried to install it. I started to set the configuration.h and uploaded it to the board with no problems.
When I run Repetier host (V0.56 OSX) It says Unknown Firmware. The strange thing is that if I change back the type of printer (#define DRIVE_SYSTEM 3) to cartesian (0) It recognise the firmware fine and I'm able to move the Steppers.
- Dose anyone had similar Issue?
- Would there be an incompatibility between the delta mode & the Gen7?
I'll continue to give it a go but in parallel I will try the mdified Marlin.
Thanks for your feedback
Kolergy
This a bit a newbee question, I am building a Rostock like delta printer controlled by Gen7 1.4.1 (Atmega 644 @20Mhz I expected the little overclock of the gen7 could be beneficial on a delta where controller speed is an issue)
Since the Repetier Firmware (V0.82.2) which seems the most advanced for delta printers I tried to install it. I started to set the configuration.h and uploaded it to the board with no problems.
When I run Repetier host (V0.56 OSX) It says Unknown Firmware. The strange thing is that if I change back the type of printer (#define DRIVE_SYSTEM 3) to cartesian (0) It recognise the firmware fine and I'm able to move the Steppers.
- Dose anyone had similar Issue?
- Would there be an incompatibility between the delta mode & the Gen7?
I'll continue to give it a go but in parallel I will try the mdified Marlin.
Thanks for your feedback
Kolergy