Hi everyone - thinking about switching to the Repetier firmware from Marlin and I'm trying to define my extruder thermistor.
I'm using a Budaschnozzle which comes w/ a Honeywell 135-104LAG-J01. In Marlin, I can select that particular thermistor because all the thermistor values are defined in "thermistortables.h" How do I use those values in the Repetier firmware? are those thermistor tables stored someplace else?
I looked at the documentation (http://www.repetier.com/documentation/repetier-firmware/rf-installation/) and the section on temp. measurement went over my head pretty quickly, and I don't have the experience to kludge this out....so maybe the least complex solution might work best.
thanks!
I'm using a Budaschnozzle which comes w/ a Honeywell 135-104LAG-J01. In Marlin, I can select that particular thermistor because all the thermistor values are defined in "thermistortables.h" How do I use those values in the Repetier firmware? are those thermistor tables stored someplace else?
I looked at the documentation (http://www.repetier.com/documentation/repetier-firmware/rf-installation/) and the section on temp. measurement went over my head pretty quickly, and I don't have the experience to kludge this out....so maybe the least complex solution might work best.
thanks!