1.02 configuration tool unexpected moving core x y (no replies)

I write again about this situation because I don't find a real solution for it
I build a core xy and i intend to use repetier firmware on my ramps 1.4
my problem is after uploading the firmware my printer is not moving right

my printer is core xy full discount display ramps 1.4

if i try moving on x +, my printer go on x
if i try moving on x -, my printer not moving
if i try moving on y +, my printer is moving on - x - y
if i try moving on y -, my printer not moving
somebody tell me something like i don't provide library for 1.8.x for endstop - which i don't understand

I have arduino 1.8.5 updated all libraries
I don't find any setting for endstop closed by core xy functionality
iI dont find any setting on steppers motor closed to core xy
the only setting i found is on General where I tell is an core xy
I upload my configuration which is working on old arduino