[attachment 79067 Head.jpg]
Hello
I'm working on delta printer design. This printer will be able to swing and pack the extruder when it's not used.( see the picture attached)
To do that I use an actuator driven by a 5 V binary signal ( 0 => extruder 1, 1 => extruder 2) so I need to drive an output every extruder switching.
Is it possible to do that with the slicer ?
Big thanks for you help .
Hello
I'm working on delta printer design. This printer will be able to swing and pack the extruder when it's not used.( see the picture attached)
To do that I use an actuator driven by a 5 V binary signal ( 0 => extruder 1, 1 => extruder 2) so I need to drive an output every extruder switching.
Is it possible to do that with the slicer ?
Big thanks for you help .