Hi all,
I have finally got my printer with a dual extrusion. Currently I have the offset (+18mm in X axis) between the two extruder nozzles set in Slic3r. It works great but previews also have the extrusion offset in the preview.
In firmware there is the ability to have the offset in Repetier (0.92.3) which wants it as steps - has anyone used this? Do I simple take my 18mm offset and multiply it by the steps/mm of the x axis?
I have finally got my printer with a dual extrusion. Currently I have the offset (+18mm in X axis) between the two extruder nozzles set in Slic3r. It works great but previews also have the extrusion offset in the preview.
In firmware there is the ability to have the offset in Repetier (0.92.3) which wants it as steps - has anyone used this? Do I simple take my 18mm offset and multiply it by the steps/mm of the x axis?